Here comes a similar problem:
Peugeot Boxer 2012 2.2hdi SID208, Autotuner read ID ok, but won’t read on bench, won’t read via OBD too.
Solution:
Bench mode:
On bench must use an external power supply. Try 13.8 to 14.4v. Sometimes you need try many times.
Had same error on bench but you can get it, here is the procedure :
– Open ecu
– Connect the boot pads and you can get the schematic from ford transit sid208
– Then read it on bench by choosing Peugeot boxer sid208
And it’s done 100/100 sure!
OBD mode:
Better do it via OBD in car.
This was one of Autotuner‘s highest selling points when they released the tool that it could do them by OBD with quick read / write times.
If you fail to write via OBD, try
1). Start the Vehicle a few times then they usually read.
2). Shut everything down and try again.
3). Turn all consumers off, if fails keep retrying ignition off and on.
4). Use some OBD extension cable with thick pins, Autotuner OBD pins very tiny and PSA obd socket is shit too, had similar issues couple of times.
comment here